Don't know which Timber Preservative to buy? Let Us help you with our step by step guide to select the best timber treatment.

Clear Wood preservative

$35.50$238.13 (Inclusive of GST)

Timber Care Wood Preservative 4LITRES
Timber Care Timber preservatives Wood Preservative 20lITRES

Clear Wood preservative

(1 customer review)
5.00 out of 5 based on 1 customer rating

$35.50$238.13 (Inclusive of GST)

Clear Wood Preservative timber Protective is a penetrating timber preservative and not a coating that remains on the surface. It is ideal for application to timbers used in window frames, external doors, gates, fences, posts, hand rails, outdoor furniture and any situation where exposure to rain, moisture, insect pests and weather may promote degrade. CWP is also effective in areas where timber, although not directly exposed to weather, is subject to damp conditions with poor ventilation such as around wet areas in houses and under floors with low ground clearance. It must be stressed that use of a product such as CWP will generally not provide the same level of protection as pressure treatment. In most cases, with surface applied preservatives, periodical reapplication will be required.
SKU: N/A Category:


Directions For Use

Timber to be treated should be dry and clean. Any old paint, stain or surface moulds should be removed before application. Recommended application method is by flood brushing, direct injection into affected areas or where convenient total dip or immersion for one or two minutes. For surface treatments the required absorption of CWP is 0.25 litres per square metre (1 litre per 4 square metres) One application may be sufficient in most cases. Allow at least 24 hours before a second application if it is required. Coverage will vary from approximately 4 to 8square metres per litre depending on the timber species, moisture content, and surface condition. It is important that all surfaces are coated to ensure effective protection. All cutting, drilling, machining or planning should be done before treatment. Timber components should be treated before joining or fixing.


Timber treated with CWP should be touch dry within a few hours of application. CWP may slightly darken some timbers. Clean up brushes and equipment with mineral Turpentine. In exposed exterior situations without the protection of additional paint or stains, re-application is recommended after 6-12 months. Longer term protection will be obtained if the timber is coated with suitable exterior paint or stain (such as TWA Water Repellent). CWP should be re-applied as recommended as part of the re-application of the paint or stain.

First Aid Instructions

If poisoning occurs, contact a doctor or Poison Information Centre (13 11 26).
Hold eyes open, flood with water for at least 15 minutes – see a doctor.
Remove contaminated clothing and wash skin thoroughly with soapy water.
Remove to fresh air.
If Swallowed
DO NOT induce vomiting. Give a glass of water to drink and transport to hospital.

Additional information



1 review for Clear Wood preservative

  1. Dave Kirk

    After using your woodcare wood preservative I have found this product very easy to use and provide the protection it says it will, I have been using this product for approximately two years now and my fence looks as good a condition as when I installed it approximately two years ago. I would have no hesitation whatsoever as to recommending this product.

Add a review

Your email address will not be published. Required fields are marked *